Check Out The Peugeot Keys Tricks That The Celebs Are Using
Peugeot 208 Key Replacement
It is better to leave the replacement of Peugeot keys for 208 to auto locksmiths with the equipment and knowledge. They will be able to make and program new keys much quicker than a dealership and at a lower price.
A dead coin battery is the most likely cause if your key fob stops locking or unlocking the doors. There are many other reasons that the key might be malfunctioning.
Dead Coin Battery
A dead coin battery will prevent your Peugeot 208 from locking or unlocking, and won't start the engine. If this is the case, you'll need to make use of the backup starting procedure that is detailed in the owner's manual for your vehicle.
The spark plugs can also be worn out. The spark plugs light the fuel to start the engine. They have a limited life span. If they are not used enough to last, they'll eventually fail.
Luckily, there's an easy solution to this problem. Examine the voltage of your battery using a multimeter. If the voltage is lower than 11,5 volts, it's time to replace it. It is also important to clean the battery's contacts in the event that it is damaged by corrosion. This can be done by lifting the rubber covers that protect the two terminals on the battery and using a wire brush to remove any parts that are corroded from the battery. Then, reconnect the cables that connect the positive and negative poles.
Water Damage
If your 208 won't start and the battery isn't flat then you should check that the spark plugs are functioning. It is possible that they're filthy, making them unable to spark. The spark plugs can be cleaned in the workshop.
Peugeot cars have keys that are transponder-type and works with the car's ignition system. This ensures that only the correct key can turn the engine. If the chip in the Peugeot key is damaged, it won't send the correct signal to the vehicle.
Water damage is the most common reason for this issue. This is a common issue in more cold climates where the car has been exposed to rain or snow. In this instance, you should contact a reputable locksmith who has the required tools and equipment to change the key's programming. They will also have the most up-to-date technology and equipment needed to make a Peugeot 208 smart key. The process should take no more than 15 minutes.
Contacts to the battery are not working properly.
Peugeot replaced the old transponder chips with a brand new type that uses electronic components mounted on a circuit board. This new technology works great when it's fresh, but as time passes, the circuit boards start to deteriorate and stop working properly.
This can prevent the immobiliser from activating so your vehicle will not start. Contact an Peugeot specialist or a locksmith if this is the case.
A common issue occurs when the battery inside the key fob begins to die. This causes the blade of the key to stop feeding into your lock. A locksmith in your car will replace the battery, and then cut a fresh blade for you. This is a simple solution.
Faulty Receiver Module
It could be that the receiver module is defective when your Peugeot key fob isn't working after being dropped on the floor, or exposed to a sudden downpour or accidentally washed. The receiver module is responsible for transmitting radio frequency to the onboard computer that manages the central locking system of your Peugeot vehicle.
The key fob itself has rubber seals to prevent water from reaching the chip inside. The chip can be damaged by water when it is exposed to the water for an extended period of time. The high salt content in the ocean or pool can cause damage to the key fob if it is submerged.
The module must be replaced if the Peugeot spare key is no longer working. This is only done by an Peugeot specialist or an expert auto locksmith. Peugeot keys, unlike other cars, are secured by an immobilizer system. This requires the correct codes to start the car. It is for this reason that you should only rely on a Peugeot locksmith to create and program an alternative.
peugeot 2008 key www.g28carkeys.co.uk On-Board Computer
The computer on board in your Peugeot is responsible for a number of the systems within your vehicle, from power windows to airbags. The on-board computer will display the code when something goes wrong. This code is saved in the system and stays there until the issue has been resolved. This will often require the on-board computers to be replaced.
One of the most frequent causes of the airbag light flashing is loose or corroded connections within the airbag sensor. This can be caused by wear and tear, aging, or exposure to moisture and salt. It is crucial to get this issue addressed as quickly as possible, since a malfunctioning airbag can be dangerous in the event of an accident.
If you find a card not found error on your Peugeot key fob, the battery inside the key fob may be dead or weak. This will prevent the key fob from sending a signal that disarms the standard immobilizer in your vehicle. You can test this by pressing the unlock button on the key fob, then trying to start your vehicle. If this doesn't work, the key battery must be replaced.